WEICON LOCK PEN SYSTEM AN 305-42 , 50 ml

WEICON LOCK PEN SYSTEM AN 305-42 , 50 ml

medium viscosity
medium strength
disassembly with normal tools
Retaining cylindrical assemblies for bearings, shafts and bushings,
marking-free

Hydraulic and pneumatic sealing, DVGW certificated, marking-free

Surface pre-treatment
In general, WEICONLOCK does not require special pre-treatment
as slightly oily surfaces (e.g. on as received parts) will be tolerated.
However, best results will be achieved on cleaned, degreased parts
(use WEICON Surface Cleaner). If required, the parts should be
slightly roughened.

Processing
WEICONLOCK is ready for use and should be applied evenly direct
from the bottle/tube with the dispensing tip (avoid direct contact of
dispensing tip with metal). Apply WEICONLOCK in circular motions
on the thread. Screw pipe threads together and tighten until desired
orientation. When using as flange sealing apply a continuous bead
on one side. Join and tighten parts quickly. Do not pour back into
the bottle any WEICONLOCK fluid which had contact with metal;
even smallest metal particles will cause the content of the bottle
to cure. In series construction, the use of manual or automatic
applicators is recommended.