- Reviews (0)
- Support Document
- Vendor Info
- More Products
ASV SS 185 SB Stainless Steel Coating
Protective Stainless-Steel Coating Containing Pure SS 316L Pigments.
SS 185 SB is a high-performance coating designed to provide protection to stainless steel. It air dries fast on application to leave a coating with stainless steel 316L pigments. It is a single component ready to use protective film SS 185 SB does not contain any chlorinated solvents, CFCs, or ozone depleting chemicals.
Effective for industrial, mining, construction equipment piping, storage tanks, structural steels, welding seams on stainless steel.
Directions for Use
Clean and degrease the surface prior to application. Remove all rust and loose scales by wire brush. Shake can well for a couple of minutes till bearing noise from inside the can is audible. Repeat the same before every application. Spray light, even coats with sweeping action of the hand onto completely dry surface. Allow solvents to completely evaporate before re-application. Drying time to touch is about 10-15 minutes, to handle is about one hour and for complete cure is about 24 hours. Flush away paint products or product residues in the dip tube of the valve by cleaning it. Cleaning of the valve should be performed after spraying is finished, by inverting the can and pressing the actuator button in short bursts till only the propellant comes out. If required, to prevent clogging, remove the actuator button and clean the button orifice with a thin, fine wire.
Contains flammable solvents and propellant. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation.
- Vendor: admin
- No ratings found yet!