ASV RNC 10 Wax Based Corrosion Inhibitor 500ml


ASV RNC 10 Wax Based Corrosion Inhibitor 


Corrosion Inhibiting Wax Coating

Product Description

ASV® RNC 10 is a thin dry waxy film type corrosion inhibitor for providing short-term protection from rust and corrosion for up to 9 months indoors under normal storage conditions. It forms a light protective film over the surface and seals out entry of moisture & corrosion. Its dry nonstaining formulation resists dirt & dust build up and is safe for use on all metals.

ASV® RNC 10 does not contain any CFCs or any ozone depleting substances.


Corrosion Protection for metal parts in storage, manufacture, shipping or in service as:

Dies, Jigs, Tools, Molds, Instruments, Solenoids, Welds, Castings, Shafts, Motors, Spare, Parts, Freshly Machined Surfaces

Directions for Use – Bulk

Apply onto clean, dry and degreased surfaces by means of brush or by dipping components into the fluid. Ensure removal of rust, loose scales, dirt, dust and trapped moisture from surfaces before application. Mask areas not required to be coated. Apply uniformly a light film for maximum coverage. Two light films are better than a single thick film. For thicker films, recoat only after previous coat dries. Reuse as required.

Directions for Use – Aerosol

Shake can till bearing noise from inside is audible. Spray liberally, a light and even film onto the surface. Spray on to clean and degreased surface and remove dirt, rust, scales, dust and entrapped moisture prior to application of this product. Allow solvents to evaporate and film to dry before recoating. Reuse as required. Caution Contains flammable propellant and solvents. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation.



ايه اس في


There are no reviews yet.

Be the first to review “ASV RNC 10 Wax Based Corrosion Inhibitor 500ml”

Vendor Information

  • Vendor: admin
  • Address:
  • No ratings found yet!
You've just added this product to the cart: